4) You will need to have on hand water leak tape, small gas torch, solder, flux, plumbing sandpaper, pipe cutter, gas tape (to seal gas line) and maybe some pipe glue. Ask the sales person at the hardware store for a more defined list.
The wax ring is used to seal the drain outlet on the bottom of the toilet to the drain opening in the floor. When a toilet is installed, the ring is placed onto the drain... the toilet is dropped onto the ring... and the toilet bolts (also known as closet bolts) are tightened enough to lock the toilet in place. If that wax gasket ring starts to fail or isn't seated properly? Sewer gasses can sneak out from under your toilet causing your bathroom to have that suspicious smell. It can also cause water line repair to escape, sometimes invisibly, with each flush potentially damaging the floor hidden under the toilet.
If you need to add copper pipe make sure that you clean the old and new pipe by using sandpaper, inside and out. If it's not clean the solder will not flow into the joint. Another tip is to not over wrap the mail threaded pipe with tape, this can cause a leak. Twice around should be enough. Also, don't over tighten it.
Clean the hole in the gutter railing first. It must be free of any debris, so you may want to clean the entire drain channel using a proper cleaner. In this way, you will have a clean surface area which will allow you to repair the hole more easily.
As with anything, when you are not sure how to fix a plumbing issue and when you don't have the proper equipment, you should contact a professional. They can usually find out what the problem is and resolve it for you in a short period of time. They will also be able to tell you if you have any other problems and water line repair they can suggest resolutions.
99. With the large genoas it is difficult to see under the headsail. If sailing off the wind, harden up momentarily and sail for a few seconds closer to the wind and to observe the arc which had previously been blanketed. If sailing close hauled, bear away for a few moments.
Then, you can take your new shower parts home and reinstall them in the inner assembly. It is very important that everything be aligned properly and tightened to prevent leaks. Beware of over tightening, however, since this can also cause problems. Once you are sure everything is installed properly, replace the cover plate and turn the water back on to test your repair work. With a little bit of work, your do-it-yourself shower repair project can be a success. It does not take an expert, just a little effort and know how.